steel02 pushover curve error

Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe

Moderators: silvia, selimgunay, Moderators

Post Reply
rao
Posts: 1
Joined: Tue Jan 09, 2024 8:33 pm

steel02 pushover curve error

Post by rao »

Hello everyone.
I model a 3D steel pile wharf model. I used "Steel02" Material for piles and use dispbeam column elements.
my modal analysis shows good time period match with my abaqus results and dynamic analysis also seems good but when I apply pushover analysis, my Pushover curve does not fall and I increased the target displacement up to 10 meter then my curve does fall at 6 meter disp which is very high. i checked all material properties many times. i don't know where is the problem.
thanks. Image
Post Reply