Dear ZouatineMohamed,
Thank you for providing the details of your OpenSees model and the convergence issue you are facing. The error message you shared indicates a convergence problem during the dynamic analysis. Below are some suggestions to help you address the non-convergence issue:
Increase Convergence Tolerance:
Try increasing the convergence tolerance (Tol) in your analysis. Sometimes, a more relaxed tolerance can help the analysis converge, especially in cases with non-linear behavior.
Check Time Integration Parameters:
Adjust the Newmark time integration parameters. You can experiment with different values for the gamma and beta parameters.
Code: Select all
ops.integrator('Newmark', 0.6, 0.3) # Adjust gamma and beta values
Check Damping Parameters:
Ensure that the damping parameters are appropriate for your model. You may experiment with different damping ratios to see their effect on convergence.
Code: Select all
xDamp = 0.03 # Adjust damping ratio
Check Initial Stiffness Proportional Damping:
If your model experiences abrupt changes, you might consider including initial stiffness proportional damping.
Code: Select all
betaKinit = 0.02 # or another suitable value
Check Load Pattern:
Verify the load pattern and the applied acceleration time series. Ensure that they are consistent with your expectations.
Check Eigenvalue Analysis:
Perform an eigenvalue analysis separately to ensure the stability of the structure and the correctness of the applied damping.
Review Material Parameters:
Double-check the material properties and their behavior under dynamic loading. Ensure that the material models are suitable for the range of deformations encountered.
Use Smaller Time Steps:
Try reducing the time step size (DtAnalysis). A smaller time step can sometimes help in capturing the dynamic behavior more accurately.
Code: Select all
DtAnalysis = 0.01 # or a smaller value
Check for Instabilities:
Investigate if there are any instabilities in your model that might be causing the convergence issues. This includes checking for negative or zero stiffness, element distortion, or other numerical instability sources.
After making adjustments, gradually increase the intensity of the ground motion and observe if the convergence issues persist. If the problem still exists, you may need to perform a more detailed analysis of your model's dynamic behavior and review the applied loads and boundary conditions.
I hope these suggestions help in resolving the convergence issues in your OpenSees model. If you have further questions or encounter any difficulties, feel free to provide additional details for more targeted assistance.
Best regards,