rigidDipahragm Constraint of Degrees

[ParkSangWoo]

Hello everyone

I am using rigidDiaphragm. At this point, changing the constraint of degrees of freedom from 010101 to 001110 will result in numeric analysis returns 1 — umfpackgenlinsolver::solve error.

Is there a solution? Or should I only use 010101 for rigidDiaphragm constraints?

Thanks in advance.

[selimgunay]

It depends on your global axes, is the Z axis along the height of your building?

[ParkSangWoo]

The height of the building is along the global y. thank you

[johnsmithpk]

I’m really happy to say it was an interesting post to read. I learned new information from your article, you are doing a great job. Continue svg files