Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe
Moderators: silvia, selimgunay, Moderators
-
cctvcctv
- Posts: 48
- Joined: Mon Apr 04, 2005 9:45 pm
- Location: UC Irvine-Utah State University
Post
by cctvcctv » Sat Jun 04, 2005 5:27 pm
every time, it will say: invalid command
-
silvia
- Posts: 3909
- Joined: Tue Jan 11, 2005 7:44 am
- Location: Degenkolb Engineers
-
Contact:
Post
by silvia » Sun Jun 05, 2005 7:39 am
how did you actually spell UniaxialMaterial?????
also, before you can use any OpenSees commands in tcl you have to use the model builder command.
Silvia Mazzoni, PhD
Structural Consultant
Degenkolb Engineers
235 Montgomery Street, Suite 500
San Francisco, CA. 94104
-
cctvcctv
- Posts: 48
- Joined: Mon Apr 04, 2005 9:45 pm
- Location: UC Irvine-Utah State University
Post
by cctvcctv » Sun Jun 05, 2005 10:28 am
i use model command, 3d 6 dof/nodes
-
silvia
- Posts: 3909
- Joined: Tue Jan 11, 2005 7:44 am
- Location: Degenkolb Engineers
-
Contact:
Post
by silvia » Mon Jun 06, 2005 3:09 am
please post your script.
Silvia Mazzoni, PhD
Structural Consultant
Degenkolb Engineers
235 Montgomery Street, Suite 500
San Francisco, CA. 94104