PlasticDamageConcrete3d or PlasticDamageConcretePlaneStress

Forum for asking and answering questions related to use of the OpenSeesPy module

Moderators: silvia, selimgunay, Moderators

Post Reply
mohammmad
Posts: 38
Joined: Tue Aug 21, 2018 4:10 am
Contact:

PlasticDamageConcrete3d or PlasticDamageConcretePlaneStress

Post by mohammmad » Fri Oct 09, 2020 3:04 am

Hi

Does any one know that "PlasticDamageConcrete3d "or "PlasticDamageConcretePlaneStress" work?

Are inputs ok (N,m, sec)?

##nDMaterial PlasticDamageConcretePlaneStress $tag $E $nu $ft $fc
nDMaterial PlasticDamageConcretePlaneStress 1 30.0e9 0.2 2.0e6 -35.0e6

mhscott
Posts: 508
Joined: Tue Jul 06, 2004 3:38 pm
Location: Corvallis, Oregon USA
Contact:

Re: PlasticDamageConcrete3d or PlasticDamageConcretePlaneStress

Post by mhscott » Fri Oct 09, 2020 1:14 pm

I don't know if they work. Does it work better if you make the $fc input positive instead of negative?

mohammmad
Posts: 38
Joined: Tue Aug 21, 2018 4:10 am
Contact:

Re: PlasticDamageConcrete3d or PlasticDamageConcretePlaneStress

Post by mohammmad » Fri Oct 09, 2020 9:55 pm

mhscott wrote:
Fri Oct 09, 2020 1:14 pm
I don't know if they work. Does it work better if you make the $fc input positive instead of negative?
I tried but the $fc input positive instead of negative did not work too.

Post Reply