creating cyclic protocol

Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe

Moderators: silvia, selimgunay, Moderators

Post Reply
nilz
Posts: 34
Joined: Sat Nov 12, 2016 7:03 am
Location: Ferdowsi university of mashhad

creating cyclic protocol

Post by nilz » Fri May 04, 2018 10:11 pm

Dear all

For creating a cyclic protocol based on AISC 341-16, how calculate the parameters below for our model?

Δbm = value of deformation quantity, Δb, at least equal to that corresponding to the design story drift, in. (mm)
Δby = value of deformation quantity, Δb, at first yield of test specimen, in.(mm)

Post Reply