Hi all,
I am running the analysis of a 6 storey RC structure. Analysis runs up to 12cm displacement with 12Mpa concrete and the curve is a straight line like in linear behavior. When I use 20Mpa concrete dispControl wont run a single iteration. Does anyone have any idea what going on with this?
Cheers
Material Concrete01
Moderators: silvia, selimgunay, Moderators
Re: Material Concrete01
I suggest you do some single degree of freedom analysis with a truss element looking at stress-strain responses of the materials to ensure you have the parameters correct.
If o.k. then your analysis script needs some modification, i.e. smaller steps or alternative algorithms.
If o.k. then your analysis script needs some modification, i.e. smaller steps or alternative algorithms.