Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe
Moderators: silvia, selimgunay, Moderators
-
christhestampede
- Posts: 6
- Joined: Tue Jun 10, 2008 11:09 am
Post
by christhestampede » Tue Jun 17, 2008 12:52 pm
I was attempting to model a multi-story, multi-bay structure as in example 5 and create definitions for concrete and steel materials to try to model a reinforced concrete section, but when I ran my source, I got this error:
Code: Select all
invalid command name "uniaxialMaterial"
I went back and checked the spelling and cases very carefully, but I dont think that was the problem because I also ran the example source (
http://opensees.berkeley.edu/OpenSees/m ... ialsRC.tcl)
and I got the same error. Why isn't OpenSEES recognizing my command? Thank you again in advance
-
mugezeas
- Posts: 1
- Joined: Mon Nov 28, 2016 10:40 pm
- Location: HOHAI UNIVERSITY
Post
by mugezeas » Sat Jul 15, 2017 6:25 am
I have got exactly the same problem.
I have got the same error message .
Any help on how to solve it will be appreciated.